error code e000000 in ir 2520

[GODLOVE]

Hi everybody!
Thank you for accepting me here.
I am Godlove from Tanzania, East Africa.

I have may Canon ir 2520 that when i tray to shoot on it gives a error message above (error code e000000 in ir 2520) if any one can help me to find solution. I have triad to replace a new HVT it still does the same

[_SuabE_]

Re: error code e000000 in ir 2520

Hi everybody!
Thank you for accepting me here.
I am Godlove from Tanzania, East Africa.

I have may Canon ir 2520 that when i tray to shoot on it gives a error message above (error code e000000 in ir 2520) if any one can help me to find solution. I have triad to replace a new HVT it still does the same

It is fixing error just reset it from the service mode.

Cheers

[GODLOVE]

Re: error code e000000 in ir 2520

It is fixing error just reset it from the service mode.

Cheers

Thank you for your respond. Well i did try to clear it bay entering Service Mode >CLEAR>ENGIN>ERRCLR enter Service Mode >CLEAR>ENGIN>ERRCLR and finally power cycle the machine. It Cycle for a while then stop and turn again to the previously state of error e000000. If i may ask if is something to do with the blue n red cables on the Engine control er Circuits? Because i changed all to a new Control circuits or is something else ?

[GODLOVE]

Re: error code e000000 in ir 2520

Thank you for your respond. Well i did try to clear it bay entering Service Mode >CLEAR>ENGIN>ERRCLR enter Service Mode >CLEAR>ENGIN>ERRCLR and finally power cycle the machine. It Cycle for a while then stop and turn again to the previously state of error e000000. If i may ask if is something to do with the blue n red cables on the Engine control er Circuits? Because i changed all to a new Control circuits or is something else ?

Hello pleas help me with this problem. and if possible someone send an electrical wiring manual of this machinery

[GODLOVE]

Re: error code e000000 in ir 2520

Hello pleas help me with this problem. and if possible someone send an electrical wiring manual of this machinery

Helow! I hope someone is goner help me with a solution to my Machinery
I m still waiting

Thank you Technical Friends

[doktor]

Re: error code e000000 in ir 2520

Replace fixing unit end reset than try with old unit.

[copier tech]

Re: error code e000000 in ir 2520

If you got the E0000 error AFTER you replaced any boards & you can't reset it in service mode I would suggest that you have a loose connection somewhere, go back & check the work you did.

If all looks good then may just be a coincidence & you'll need to replace the fixing film ass'y

[GODLOVE]

Re: error code e000000 in ir 2520

If you got the E0000 error AFTER you replaced any boards & you can't reset it in service mode I would suggest that you have a loose connection somewhere, go back & check the work you did.

If all looks good then may just be a coincidence & you'll need to replace the fixing film ass'y

Thank you friends! I have removed older fixing and replace another one. Then shoot On the machinery started and engine rotate on its normal way. There after it change onto e000246. What do i do?

[cdtw9803]

Re: error code e000000 in ir 2520

Thank you friends! I have removed older fixing and replace another one. Then shoot On the machinery started and engine rotate on its normal way. There after it change onto e000246. What do i do?

E246 means that AC power supply is not normal or bad power supply pcb.