[Error Code] C700 imagePRESS Fixing question

[fatfingers73]

Hi all,

Just replaced upper & lower units on one of these and reset counters.

It's still saying 'fixing unit needs to be replaced'.

Any ideas?

Any other counters that need resetting at certain points?

Cheers

[charm5496]

Re: C700 imagePRESS Fixing question

sounds like you a have an issue with the drive system on the fixing drive. There have been issues the lack of grease on the main drive gear, so you may want to check the condition of yours.

[khattab.al.masry]

Re: C700 imagePRESS Fixing question

(Lv.1)
COPIER >
OPTION >
DSPLY-SW
OPEMANT>
ON/OFF of operator maintenance modeTo set ON/OFF of operator maintenance mode.
When 0 is set, operator maintenance mode is not displayed.
When 1 or 2 is set, "Operator Maintenance Mode" is displayed in
Settings/Registration menu.
When 1 is set, sub parts counter can be managed individually at
replacement of the Fixing Assembly.
When 2 is set, sub parts counters are cleared collectively at
replacement of the Fixing Assembly.1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
(Lv.2)
COPIER >
OPTION >
DSPLY-SW
OP-ALMT>
Set warning mssg timing in operator mntc:
To set the timing to display warning message of parts replacement/
cleaning counter in operator maintenance mode.
With this setting, warning message is displayed once before reaching
the specified life of parts or number of sheets for cleaning.
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.

[khattab.al.masry]

Re: C700 imagePRESS Fixing question

service mode
level 2
copier
dsply-sw
fxmsg-sw set to 0