[Misc] Locate the Version of your Installed Canon Printer Drivers

[teckat]

Determining the Version of the Installed Canon Printer Driver

To obtain information about your installed driver, such as the version, following the steps below.
Canon Fax, UFRII, PCL5e/PCL5c/PCL6 and PS3 Drivers:
1. Go to the Printers folder in Windows.
2. Right click on the installed printer and select Properties.
3. Select the Device Settings tab.
4. Click the About button.
pcl_info.jpg
Fiery PS Drivers:
1. Go to the Printers folder in Windows.
2. Right click on the installed printer and select Properties.
3. Click the About tab.
ps_info.jpg

[mrfixit51]

How does one find the IR3220 Fiery version, C1 or C2 & what is the difference please?

I believe from the Printer Configuration Page you print out.

[ReproKev]

How does one find the IR3220 Fiery version, C1 or C2 & what is the difference please?

The C1 has a power switch on the side. I'm pretty sure the C2 does not.

[mrfixit51]

The C1 has a power switch on the side. I'm pretty sure the C2 does not.

You are correct sir!

[teckat]

How does one find the IR3220 Fiery version, C1 or C2 & what is the difference please?

imagePass C1 v2.0 Intro TP04-1.pdf
imagePass C2 Intro TP06 116.pdf

C2.JPGC1.JPG

[teckat]

Before attaching an imagePASS-C2, verify that Color imageRUNNER C3220/2620 has software/firmware of the following versions or later:System Software (MN-CONT)
82.03


The imagePASS-C2 can only be turned ON/OFF using the copier’s main power switch. This feature is made possible by the imagePASS-C2’s PCC PCB.
The Power Control Circuit (PCC) allows the imagePASS-C2’s independent AC Power Supply to be controlled by the copier’s main ON/OFF switch. In order to accomplish this, a signal is sent along the Open Interface Cable from the copier to the imagePASS whenever the copier’s main power switch is turned ON/OFF. The PCC PCB monitors this signal and uses it to determine whether or not power should be sent from the power supply to the motherboard of the imagePASS. The main power switch on the copier will dictate whether or not power is sent to the motherboard of the imagePASS.

In order to turn OFF the imagePASS-C2 (from a full running state), the imagePASS-C2 must first be shutdown via the operation panel of the copier. Then the copier’s main power switch can be turned OFF.
When servicing the imagePASS-C2, it is important to turn OFF the copier’s main power switch (as this will also turn off the imagePASS-C2) and to disconnect the power cable from the imagePASS.

[teckat]

Thumbs up.jpg

[mrfixit51]

Many thanks. I was a little confused, as I know now I we have an IR3200 with the C1 firery, but the version says 2.1 I guess that is the firery firmware version!?

Correct, that is the info in the first paragraph of the configuration page I spoke of...

[bipc]

Thanks for the info, never had the chance or plesure to work with any kind of image pass, small place with only small companys so mostly small o medium canon machines, biggest we have worked with was a IR5000 copier standalone, but still great to see wath's going on around