IRC2880i

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • msmy
    Trusted Tech

    100+ Posts
    • May 2010
    • 123
    #1

    [Misc] IRC2880i

    Hi guys,

    I just change all four new drums (genuine). However, the problem is begun (attached). Please help me.

    IRC2880i.jpg
    Tags: None
    • mjarbar
      #2
      Re: IRC2880i

      If the machine hasn't reported any error codes, check to make sure the ITB assy is in place and locked in position as it is still possible to push the process unit in without it locked down. This means the transfer doesn't make proper contact with the drums and PCQ results. Also ensure (if you haven't already) do a full auto grad adjustment.


      If it has given error codes please let us know as we can help - we have the power to rebuild!!!

        Comment

        • roller
          Technician
          • Apr 2010
          • 26
          #3
          Re: IRC2880i

          Originally posted by msmy
          Hi guys,

          I just change all four new drums (genuine). However, the problem is begun (attached). Please help me.

          [ATTACH=CONFIG]17258[/ATTACH]
          Perhaps you apply too much force when closing ITB assembly. Open and close it again, push down on front and rear side at the same time until you hear "click".

            Comment

            • msmy
              Trusted Tech

              100+ Posts
              • May 2010
              • 123
              #4
              Re: IRC2880i

              I open the ITB unit and close it again. Checked again and again. however same result. NO ERROR CODE. JUST BLUR..

                Comment

                • teckat
                  Field Supervisor

                  Site Contributor
                  10,000+ Posts
                  • Jan 2010
                  • 16092
                  #5
                  Re: IRC2880i

                  Originally posted by msmy
                  I open the ITB unit and close it again. Checked again and again. however same result. NO ERROR CODE. JUST BLUR..

                  bias tab for the transfer roller assembly can become bent and be making poor contact.

                  contact for the secondary transfer roller must touch the transfer roller shaft. The contact should be touching the bottom side of the shaft of the secondary transfer roller.

                  1. Remove the screw and then remove the black plastic contact holder shown below.
                  photo #1
                  2. Verify that the contact is touching the bottom side of the shaft of the secondary transfer roller as shown in the photo #2 below. If it is not reform the contact so that it is touching the shaft.
                  Attached Files
                  **Knowledge is time consuming, exhausting and costly for a trained Tech.**

                    Comment

                    • Beurun
                      #6
                      Re: IRC2880i

                      Clean Charger Roller Grounding Plate. Cleaned Shutters with purple stick?

                        Comment

                        • teckat
                          Field Supervisor

                          Site Contributor
                          10,000+ Posts
                          • Jan 2010
                          • 16092
                          #7
                          Re: IRC2880i

                          Originally posted by Beurun
                          Clean Charger Roller Grounding Plate. Cleaned Shutters with purple stick?
                          wash.JPG
                          **Knowledge is time consuming, exhausting and costly for a trained Tech.**

                            Comment

                            • msmy
                              Trusted Tech

                              100+ Posts
                              • May 2010
                              • 123
                              #8
                              Re: IRC2880i

                              I'll do it today (hopefully it works). thanks.

                                Comment

                                Previous template Next
                                Working...