Iot initialized

[zeckryyu]

Fuji xerox apeosport vii c3371

Machine had problem with R1 chip not detect,i tried swap drum unit its still same then i tried initialized iot,the machine now had code 116-331...i never had this problem before with other model by initialized iot,only this model..can some one explain to me what happen?

Sent from my M2003J15SC using Tapatalk

Sent from my M2003J15SC using Tapatalk

[copytech200X]

Re: Iot initialized

116-331 Invalid Log Info [IMG]file:///C:/Edoc/common_e2/images/full_a.gif[/IMG]

[Error Type]

• System Fail

[Fault Content]

• Log Management Information Incorrect
  Same as NVM failure, this failure was detected at the NVM Log management information area.

[Detection Conditions]

• A log related error was detected.

[Corrective Actions]

• Turn the power OFF then ON. If the problem persists, perform the following procedure.
  
  1. After removing the HDD and turning the power ON then OFF, install the HDD again and turn the power ON.
  
  If the problem persists, perform the following procedure to repair it.
  OF-02 HDD System Fail

[copytech200X]

Re: Iot initialized

if still NG then try initialize hard disk

[zeckryyu]

Re: Iot initialized

116-331 Invalid Log Info [IMG]file:///C:/Edoc/common_e2/images/full_a.gif[/IMG]

[Error Type]

• System Fail

[Fault Content]

• Log Management Information Incorrect
  Same as NVM failure, this failure was detected at the NVM Log management information area.

[Detection Conditions]

• A log related error was detected.

[Corrective Actions]

• Turn the power OFF then ON. If the problem persists, perform the following procedure.
  
  1. After removing the HDD and turning the power ON then OFF, install the HDD again and turn the power ON.
  
  If the problem persists, perform the following procedure to repair it.
  OF-02 HDD System Fail

I will try that,thanks for guidance

Sent from my M2003J15SC using Tapatalk